Front right turn indicator 46. The operations described below are valid for both stanchions. Slide the pin, with the split pin, fixing the linkage to the clutch to the engine block and then release the control ca- ble. If you do work in an enclosed area, make sure to use a fume extraction system. Cleaned and put back on.
Remove the gear transmission lever. Clamp that secures the ambient temperature sensor to the front headlamp support plate 5. Friend has a aeon 50 cc 4 wheeler. This manual will help you save money upwards into the thousands. I've no idea who originally created this file. I thought the mag was bad but pulled flywheel and was caked in mud.
Press the bearing tube inside the wheel holder fork leg. Checking Check that the universal joint is not damaged, the gear teeth inserting in the sleeve grooves and the grooves on the joint are not deformed or damaged;. Throttle position signal - Analogue input 12. Description Type Quantity Torque Notes Pedal rubber fastening screw M6x12 10 Nm 7. Description Type Quantity Torque Notes Rear mudguard front and central fixing screw 10 Nm 7. Motorcycles made for a design scheme, the company Moto Guzzi produced until 1976! Description Type Quantity Torque Notes Screw fastening right hand rider foot- M8x20 20 Nm 14. Right hand light switch 9.
My apologies: I do not recall where I acquired the original document. Slide the dust scraper off and upwards. This document was in that collection. Description Type Quantity Torque Notes Stanchion cap 1 + 1 50 Nm 36. Slide the complete case of the gear- case. Description Type Quantity Torque Notes Retroreflector support fixing screw to the license M5x10 4 Nm 2. Connect the vacuometer pipes to the relative joints.
Draining oil To drain out the oil follow these steps. Fit the complete pinion on the case us- ing the suitable punch 19926100. Restore the connection of the vehicle speed sensor. Insert the gaskets and the shimming ring on the cover. For the rear brake, keep the vehicle upright so that the fluid in the reservoir is at the same level with the plug.
Check that the sealing ring on the housing is not shattered or is still flexible; otherwise, replace it. Fit the upper plate on the front fork. Description Type Quantity Torque Notes Crown screws M6x16 10 Nm 7. Then, the system gives the control over the braking back to the rider. Main injection relay polarised 12. Unscrew and remove the fixing screw of the calliper holder.
Disconnect the two horn connectors. Rear right turn indicator 16. Fit the bearing on the cover using the suitable punch. Insert the oil breather pipe in the air fil- ter casing and lock it with the corre- sponding clamp. The aeon had weak spark to begin with.
The power unit was enclosed in a tubular frame duplex with a rigid rear suspension, front fork was a parallelogram. All models for the above stated years and all engine types are included. My apologies: I do not recall where I acquired the original document. Clamp that secures the main cabling to the headlamp support plate 3. Description Type Quantity Torque Notes Brake pump U-Bolt fixing screw 10 Nm 7. If you do work in an enclosed area, make sure to use a smoke-extraction system.