Disconnect the battery ground cable. The cost is also a lot 1200 pounds minimum. Check for power test light will be flickering and ground at the fuel pump connector when cranking. What else could be the problem since we already got the fuel pump replaced? It is easy, you should use the save button or place your cursor to the photo and right click then pick save as. Driving the vehicle without repairing the engine problem increases the chance of engine damage. Parking brake To set the parking brake 1 , pull the parking brake handle up as far as possible.
Take precautions to avoid its dangerous effects. If you don't and would like a copy, you can email me at with your make, model and year and I will be happy to email you a copy. Attach the new blade to the arm loop and pull it into place until a click is heard. The relay is located in the R7 position in that box see layout diagrams below. Turn all other accessories off. For more information on top tether straps and anchors, refer to Attaching safety seats with tether straps in this chapter. Lift the hood and support it with the strut in the yellow-colored retainer; ensuring it is secure.
Have to know the circuit and how things work. Have replaced the fuel pump with a tested one and still not working. When a wheel is installed, always remove any corrosion, dirt or foreign materials present on the mounting surfaces of the wheel or the surface of the wheel hub, brake drum or brake disc that contacts the wheel. The drivers primary responsibility is the safe operation of their vehicle. Confirmation is not given for the one time disable. A sudden drop in residual pressure indicates a faulty pump. My question is where is the fuel pump driver module and what does it look like? Refer to the Maintenance product specifications and capacities section in this chapter.
Start by checking the fuel pump fuse. The following table tells you which transmission or transaxle each code represents. On an Escort, it also locks the automatic seat belts down, if you have them, so y … ou stay in the seat if the door flies open during a wreck. If the fuel filler cap is venting vapor or if you hear a hissing sound, wait until it stops before completely removing the fuel filler cap. If not, contact a local tire dealer. If your vehicle has been in an accident the alignment of your headlamps should be checked by your authorized dealer. Placing objects on or over the airbag inflation area may cause those objects to be propelled by the airbag into your face and torso causing serious injury.
New battery and cranks but will not start. I like the wiring diagrams in Eautorepair. Gary Oct 28, 2013 See picture below where the fuel pump cut off switch is located. If the vehicle starts, then replace them as a pair. Make sure the headlamps and electrical accessories are off.
The only way to test it for proper operation is to remove the fuel pump and test the sensor. Do not place objects on top of the instrument panel as these objects may become projectiles in a collision or sudden stop. Unfortunitly your tank has to be removed because the pump and sensor as one unit. Restart the engine and take your vehicle to an authorized dealer. Note: In the illustrations, lightning bolts are used to designate the assisting boosting battery. That includes rust on the tank, the lock ring isn't fully seated, or the seal is cut or deteriorated.
The foglamp indicator light will illuminate. I would contact you local dealers service dept. There is no way around it. The vehicle has run out of fuel—the engine may misfire or run poorly. Remove the front splash shield from the bumper. Engine oil filler cap 4. If the safety seat in not anchored properly, the risk of a child being injured in a collision greatly increases.
There is also a rubber seal the filler tube goes through that could be not seated properly. All fuses are ok and have changed our relay also. When it wouldn't, there was nothing. Does anyone know where the fuel pump driver module is located please? Always test first,and only replace parts, if they test bad. Refer to Filling the tank in the Maintenance and Specifications chapter for more information.